16 Feet Aluminum Telescoping Flagpole Kit With 3\'x5\' US Flag and Ball Finial
Installation
Prepare a hole approximately 12" in diameter and 22" deep.
Place a bed of gravel or small rock in the hole.
Place the sleeve in the hole.
Place gravel or small rock in and around the sleeve to a height of 2" from the bottom of the sleeve. This will help drainage.
Pour concrete or cement around the sleeve, be careful not to get any inside of the sleeve.
Fill the hole approximately 1" from the ground level with the concrete.
Place the flag pole in the sleeve and level the flagpole from two sides.
When the sleeve is level, carefully remove the flagpole with out moving the position of the ground sleeve.
Let the concrete or cement set for at least 24hours.
Place pole in the sleeve and erect.
How to use your telescopic flagpole
Raising the pole-pull each section up slowly twist until it automatically locks in position starting from the top inner section.
Lowering the pole - Hold on to the section to be lowered. Press the locking button to release, twist, and allow the section to slide down slowly through the hands.
Insert the pole into the ground sleeve.
Secure Payments
